CYP QU-DP14 Specifications download pdf (Page 7)

Hardware Description

The following sections describe the hardware components of the unit.

7.1 FrontPanel

①

Power LED: The LED will illuminate in green when power on and in red

when in reset mode.

7.2 Rear panel

① ② ③ ④ ⑤

①

EDID switch INT/EXT:This switch allows user to select the built-in

EDID (INT) or the display's EDID (EXT).

Note: When the EDID switch is on EXT, the unit will detect OUTput 1's

display EDID and record in the unit. If the rst etected OUTput 1 is

not connected, it will pass to the next which is OUTput 2...... and so on

untill the display's EDID is recoreded in the unit.

RESET: Press this button every time when switch the EDID allowing the

device to update the EDID selection.

DP OUT 1 ~ 4: These slots are where you connect the DP cable or DP to

DP cable to your DP/DP input displayer for displaying a single source on

two screens simultaneously.

DP IN: This slot is where you connect the DP cable from the source

equipment for signal sending.

DC 5V: Plug the adaptor to the AC wallout for power supply to the

device.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

CYP QU-DP14 Specifications Page 7